2012-11-12
P-CUBE Photodiode Modules for Application on an Optical Bench
Press ReleaseThe Die Has Been Cast
P-CUBE Photodiode Modules for Application on an Optical Bench
Precise measurement technology in a compact measurement setup: this describes the
new P-CUBEs made by LASER COMPONENTS.
Low-noise, sensitive PIN photodiodes are housed in cubes. The CUBEs have an edge
length of only 40 mm. To integrate them into optomechanical setups, the CUBEs can
be attached to a rod system.
The following versions are available: GaP photodiode (190-570 nm), Si photodiode
(200-1050 nm), InGaAs PIN photodiode (800-2200 nm). The photocurrent is obtai-
ned using a BNC connector. The P-CUBE is also available with an optical FC connec-
tor.
iAMP-700. The programmable iAMP-700 current amplifier is directly connected to the
P-CUBE with a BNC connector. It is possible to achieve amplifications of 10 2 -10 11
V/A with the iAMP-700.
P-CUBE & iAMP – A Strong Combination. By combining the P-CUBE and iAMP-700,
the smallest amount of light can be detected reliably. The iAMP’s EMC housing allows
application in close proximity to the source. The P-CUBEs require a bias voltage bet-
ween -10 V and +10 V. This can be obtained directly from the iAMP.
More Information http://www.lasercomponents.com/de-en/product/high-sensitivity-pin-detector-modules/
More Information http://www.lasercomponents.com/de-en/product/high-sensitivity-pin-detector-modules/
